1. Insert the power supply manually, turn on the power switch, and the power indicator light will immediately light up;
2. Adjust the temperature regulator to the required temperature. When the temperature reaches the set temperature, the indication on the upper part of the temperature regulator will be off, and then work can start;
3. Adjust the time controller to the required time;
4. Place the clothes flat on the lower ironing board, then put on the ironing paper (pay attention to the front and back sides of the ironing paper), and press the handle down firmly until the end point. Attention: Do not use more than 30 kilograms of force, otherwise it may cause the handle to deform;
When the indicated time controller for hot stamping expires, the buzzer will sound, lifting the handle up to its original position.
Precautions:
1. Pressure: If the pressure is not enough or too high, the pressure adjustment knob at the back of the machine can be adjusted to increase the pressure in a clockwise direction; On the contrary, it reduces pressure;
2. Time: When the hot stamping time reaches and the buzzer does not sound or keeps ringing, if it is not appropriate, it must be adjusted to the appropriate position;
3. Temperature: When the adjusted temperature reaches, the pointer of the temperature controller points to the position of "180 ℃" (about 5 minutes to reach). If the thermometer rises while the heating plate does not heat, please check the circuit.
When the handle is pressed down to the bottom, the hand is released and the handle automatically rises. Please adjust the adjustment knob downwards.
5. When the hot stamping is completed and the handle is lifted up and feels difficult, the adjustment knob can be adjusted downwards.
