how to print on a bottle

1. Select the appropriate jigs on the left and right sides for the bottle 2. Install the selected jigs onto the fixture 3. Place the bottle between the clamps and adjust the "push" jig through the knob (at this time, pay attention to press the push and hold button ) 4. Press the "push" button, release the "hold" button,loosen the scews of clamps to adust to "hold" the bottle, so that the bottle is stably aligned with the fixture center, and then lock the screw 5. Adjust the distance between the UV lamp and the bottle by the lamp knob to be 2-4mm 6. Pay attention to the area where the bottle does not need to be printed, cover it with an iron sheet to protect the nozzle from exposure, and then turn on the UV lamp in the software to observe whether it is safe 7. Press "push" button to fix the bottle without holding it. Rotate the bottle in the software to check whether the bottle rotates smoothly,otherwise,adjust it to be smooth. 8. Remove the bottle, measure the diameter of the bottle with a vernier caliper, input the diameter of the bottle into the "diameter" , and click "download" 9. Click "Calcu" in the setting - motor - rotation motor ratio, wait for the left jig to rotate and then stop, click "Set", then click "Calcu", and then wait for stop, click "Set" again (note that the ratio value is between 0.995 and 1.007 at this time), and then save the parameter. 10. In setting - Lifter - Print Height - enter 2, click the "print Loc.", and wait for the machine head to reach the print position